GET AN ESTIMATE
Thank you for contacting Tri-Con Construction LTD, a representative will contact you shortly.
Slider
Fast-N-Stick 180 Base Sheet
This product is manufactured from a high strength polyester-reinforced mat that is saturated and coated with SBS modified bitumen to a thickness of 2.5 mm (98 mils). The sheet is top surfaced with a thin layer of polyfilm, which disappears upon heat welding of the cap sheet. Bottom surfacing has a film to prevent sticking in the roll. A double release self adhesive selvedge, incorporating a highly adhesive SBS coating, is provided for complete self-adhesive lap seaming.

Fast-N-Stick HD Base
This product is manufactured from a high strength non-woven composite polyester mat which has been strengthened with a glass fiber scrim in both machine and cross directions. This composite mat is fully permeated with asphalt then heavily coated with our select polymer blend of SBS. The top surface is covered with a thin layer of poly film, which disappears upon heat-welding of the cap sheet. The bottom surfacing is sand to prevent sticking in the roll. A double release self adhesive selvage, incorporating a highly adhesive SBS coating, is provided for complete self-adhesive lap seaming. Fast-N-Stick HD Base is a strong lay flat base sheet to be used as a mechanically fastened base sheet in the Fast-N-Weld System.

Torchflex TP-250-Cap
Consisting of a non-woven reinforced polyester mat that is coated and impregnated with SBS modified bitumen to a nominal thickness of 4.0 mm (158 mils). Ceramic mineral granules are embedded in the surface to provide U.V. protection and a poly-film is bonded to the underside (which disappears upon heat-welding). TP-250-Cap can be used as a cap sheet in a conventional BUR system, a two-ply Torchflex system, or in roof flashing. This product will conform to CGSB 37.56M and ASTM D6163

Torchflex TP-180-Cap
Comprised of a non-woven reinforced polyester mat which is coated and permeated with SBS modified bitumen to a nominal thickness of 4.0 mm (158 mils). Mineral granules are embedded in the surface to provide superior U.V. protection, while a thin poly-film is bonded to the underside. This product can be applied as the top ply in a two-ply Torchflex system, the top ply in perimeter flashings or as a cap sheet for a conventional BUR.

MP-180-FS (Cold Weather)
A non-woven reinforced polyester reinforcing mat which is impregnated with SBS modified bitumen to a thickness of approximately 2.2 mm (87 mils). This sheet is protected on the top by a thin layer of poly-film (which disappears upon torch welding of the cap sheet), and on the bottom by sand, which allows for mopping to heat-sensitive substrates and prevents sticking in the roll. MP-180-FS base sheet may be used in SBS layered membrane construction. This product conforms to CGSB 37.56M and ASTM D

Powered by YourWebPro - Roofing and Contractor Websites
Tri-Con Construction LTD Images
Close [x]